油烟罩怎么清洗及清洗注意事项!
发布人: 发布时间:2024-01-13 11:36:21
油烟罩是餐厅、酒店、学校等大型厨房必备工具,相信大家都有见过,它是用来吸取油烟的工具,油烟罩的出现解决了在烹饪时产生大量油烟的困扰,但是由于使用时间长,油烟罩里面或者表面会形成油垢,从而会影响厨房的环境卫生且有异味,也会影响油烟罩排烟效果不佳,所以建议大家要定期清洗,在清洗油烟罩要深入清洗,简单的处理清洗效果也不明显,油烟罩的清洗也是大家很困惑的问题,今天长沙不锈钢油烟罩厂家就给大家介绍一下油烟罩清洗方法吧。
The oil fume hood is a necessary tool for large kitchens such as restaurants, hotels, and schools. I believe everyone has seen it before. It is a tool used to absorb oil fumes. The appearance of the oil fume hood solves the problem of producing a large amount of oil fumes during cooking. However, due to long-term use, oil stains may form inside or on the surface of the oil fume hood, which can affect the environmental hygiene and odor of the kitchen, and also affect the smoke exhaust effect of the oil fume hood. Therefore, it is recommended to clean it regularly, When cleaning the oil fume hood, it is necessary to thoroughly clean it, and simple treatment may not have a significant cleaning effect. The cleaning of the oil fume hood is also a confusing problem for everyone. Today, the stainless steel oil fume hood manufacturer in Changsha will introduce the cleaning method for the oil fume hood.
人工进入法:对于40 cm以上的平行油烟管道可人工钻孔清理,此方法劳动强度大,需注意加强通风,配备低压(36伏特)照明电源。
Manual entry method: For parallel oil fume pipelines above 40 cm, manual drilling and cleaning can be carried out. This method is labor-intensive and requires attention to strengthening ventilation, equipped with low-voltage (36 volt) lighting power supply.
拆卸法:当烟气管道小于40平方厘米时,采用此方法,当劳动力不能进入时。技术人员根据现场的实际情况,在一定距离处移除一段烟道,并将其清洁到两侧。该方法效果好,难度大。大,成本高。
Dismantling method: When the flue gas duct is less than 40 square centimeters, this method is used when labor cannot enter. Technicians remove a section of flue at a certain distance based on the actual situation on site and clean it on both sides. This method is effective and difficult. Large, high cost.
开孔法:本方法适用于油烟管道,不能人工进入,拆卸困难。技术人员使用无火花工具在管道上开一个或多个孔。孔的大小、距离和数量取决于现场情况。清理油污后,恢复管道密封。
Opening method: This method is suitable for oil fume pipelines and cannot be manually entered, making disassembly difficult. Technicians use spark free tools to drill one or more holes in the pipeline. The size, distance, and number of holes depend on the site conditions. After cleaning the oil stains, restore the pipeline seal.
机器设备清洗法:该方法用于油烟管道的清洗时间较短。先在管道中喷洒清洁剂以软化油,然后用30米长的电软轴刷清洗油。这种方法用于30厘米平方的垂直烟道,即无法实际进入和无法拆除的隐蔽烟道。这是不容易清洁和容易积累的油,以缩短清洁周期。
Machine equipment cleaning method: This method has a shorter cleaning time for oil fume pipelines. First, spray cleaning agent into the pipeline to soften the oil, and then use a 30 meter long electric soft shaft brush to clean the oil. This method is used for vertical ducts of 30 centimeters square, which are concealed ducts that cannot be physically entered or removed. This is an oil that is difficult to clean and easy to accumulate, in order to shorten the cleaning cycle.
空降法:此法主要用于清洗50公分见方以上的竖油烟管道,技术人员先拆下管道的上截和下截,在油烟管道上方固定高空绳,系上带,技术人员从上下清洗竖油烟管道内的油污。此法危险性较大,技术性强,费用较高,清理效果好。由于竖油烟管道一般积油较少一年清洗一次较好。
Airborne method: This method is mainly used to clean vertical oil fume pipelines with a diameter of more than 50 centimeters. Technicians first remove the upper and lower sections of the pipelines, fix high-altitude safety ropes above the oil fume pipelines, fasten safety belts, and clean the oil stains inside the vertical oil fume pipelines from top to bottom. This method is highly dangerous, technical, costly, and has a good cleaning effect. Due to the fact that vertical oil fume pipelines generally have less oil accumulation, it is better to clean them once a year.
上一篇:通风管道根据制作的材料不同怎么进行分类?
下一篇:风管及管道部件设计过程中常用的计算方法
相关